Provision-ISR NVR-16400 Manual de usuario descargar pdf (Pagina 30)

5.5.2 Motion Alarm

Motion includes two sub menus: motion and schedule. The steps to set motion alarm are as

follows:

Step 1: Enter into MenuSetupAlarm MotionMotion tab. Refer to Fig 5-19:

Step 2: Enable motion alarm, set alarm hold time which refers to the time till which the

system will wait for further detection of motion. e.g. If the holding time is set to 10 seconds,

once the system detects a motion, it will go into alarm but would not detect any other motion

alarm (specific to channel) until 10 seconds. If there is other motion detected during this

period it is considered it as continuous movement, otherwise it will be considered as a single

motion.

Fig 5-19 Alarm Configuration-Motion

Step 3: The setup steps of motion trigger are similar to “Alarm Handling” (See Chapter 5.5.1

Sensor Alarm Handling setting for more details).

Step 4: After clicking Area button, a dialog box will pop up as Fig 5-20:

Fig 5-20 Motion-Area

Step 5: In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The

higher the value is the more sensitive it is to motion. Since the sensitivity is influenced by

color and time (day or night), you can adjust its value according to the practical conditions.

Left click the grid and drag to delete area. Click icon to set the whole area as detection

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Sin comentarios

Provision-ISR NVR-16400 Manual de usuario Pagina 30